Pry away the trim from around your rear windshield. Cut through the adhesive band holding the windshield. Slide a crowbar under one of the bottom corners of the windshield and pry it up. Lift the windshield and pull it out of your Dodge Dakota. Khizar Tomas Explainer. How do you install a rear window? Remove any wires that are connected to your rear window defroster. Remove the window trim and weatherstrip seal. Lift the old window out of its groove.
Use a caulk gun to apply a thin line of urethane sealant around the inside edge of the window opening. Set the new window into the groove within the window opening.
Jezabel Gayan Explainer. How do you install rear car glass? Steps Involved in Rear Windshield Replacement. Conduct an assessment of the damage. Remove all damaged glass. Ensure functionality of sensors i. Vacuum debris and broken glass in the interior and clean auto glass on the vehicle.
Delio Smissen Pundit. How do you install a rear quarter glass window? First, make sure that the glass and body panels are cleaned to remove old adhesive and any debris or contaminants. You'll need a trim panel removal tool to get around the adhesive and weatherstrip and remove the quarter glass , and the new panel of glass should be carefully placed onto the opening.
Giovana Wachtmeister Pundit. How do you replace a rear quarter window? How to Install Quarter Panel Glass. Open the rear door and remove the screws from the interior door paneling trim using the Phillips screwdriver. Remove the interior quarter panel trim. Remove the damaged quarter panel glass slowly. Check to see if there are any remnants of broken glass and remove them. Dorinda Knopfli Pundit. How do you fix weather stripping on a windshield?
Make sure that the new weatherstripping is clean. Either rinse it off and dry it thoroughly or use fine-grain sandpaper to remove any unwanted bumps and rough spots. Apply weatherstripping adhesive sparingly to the strip and to the surface of the frame. Before the adhesive dries, replace the new weatherstripping. Maksims Goldhirsch Pundit. Clean the area around the frame and in the groove where the windshield sits with a clean, wet cloth. Once your've removed any dirt, oil, or debris, dry it with a clean, dry cloth.
Lay down a band of urethane adhesive over the primer. The adhesive must go on over the primer or it will not bond to the windshield. Install the new windshield into its frame. Make sure it lays flat and even in its frame and that you install it right side up. It's recommended that you use your assistant again for this step.
Deborah McDonald has been a writer since , producing articles specializing in topics ranging from insurance and risk management to art and education. She's been published in numerous publications, including "The Lantern" and on Digg. Cracked Windshield image by Stephen Jacoby from Fotolia. Step 1 Pry away the trim from around your rear windshield.
Step 2 Cut through the adhesive band holding the windshield. Step 3 Slide a crowbar under one of the bottom corners of the windshield and pry it up. Step 4 Lift the windshield and pull it out of your Dodge Dakota. Step 5 Clean the area around the frame and in the groove where the windshield sits with a clean, wet cloth.
Step 6 Lay down a coat of urethane primer in the groove where the windshield sits.
0コメント