Standard Methods: B: Alkalinity by Titration. Summary Analytes Revisions Data and Sites. Official Method Name. This method has 1 analyte associated with it. The Water Quality Portal contains sample results from sites that use this method. Select data: Sites only Sample results only. Opening the cover will void any warranties on the equipment.
A damp cloth can be used to clean the equipment. A solid light indicates a connection to an Ethernet-enabled computer. This LED blinks during data transmission. A solid green light indicates that the modem has an IP address and is connected to the internet.
A Solid light indicates a connection is established using USB. Welcome to ManualMachine. We have sent a verification link to to complete your registration. Log In Sign Up.
Forgot password? Note: Using a power supply with a different voltage rating than the one included with the DSLB will cause damage and void the warranty for this product. Opening the cover will void any warranties on the equipment. A damp cloth can be used to clean the equipment. A solid green light indicates the unit is powered up.
A red light indicates a malfunction. A solid light indicates a connection to an Ethernet-enabled computer. This LED blinks during data transmission. A solid green light indicates that the modem has an IP address and is connected to the internet. A red light indicates that the modem does not have an IP address or authentication has failed. No light indicates that an ADSL connection is not present or the modem is in bridge mode. A Solid light indicates the DSL is synchronized. A Solid light indicates a connection is established using USB.
Pressing the Reset button restores the modem to its original factory default settings. Connect one end of the Ethernet cable to the port labeled LAN on the back of the modem and attach the other end to the Ethernet port of your computer. See the Installation Diagram on page 9. Note that either a crossover or straight-through Ethernet cable can be used.
The modem automatically recognizes the type of connection that is required. Then turn on and boot up your PC and any LAN devices, such as hubs or switches, and any computers connected to them. The following pop-up window appears when you connect the USB cable to your computer with the other end already attached to the modem. The Found New Hardware Wizard will appear on your screen. To continue, click Next. The next screen allows you to select how you want the wizard to find the driver on your computer.
The default selection is set to search for a suitable driver for my device recommended. To contunue, click Next. The file name is usbdslur. Click Open to proceed with the installation. After the file has been selected, the this screen will appear verifying the location where the file will be extracted from. Click on OK to continue. This next screen shows the device and the driver to be installed. Click Next to proceed with the installation.
The last screen confirms that the installation is complete. Click on Finish to close the wizard. Below are the procedures for configuring your computer.
Follow the instructions for the operating system that you are. Click on Local Area Connection. Listed in the window are the installed network components. If prompted to restart your computer with the new settings, click OK. After your computer restarts, click on the Network and Dial-up Connections icon again, and right click on the Local Area Connection icon and then select Properties.
0コメント