Use of either the Software or user documentation or both constitutes agreement by the U. If any portion of this Agreement or any of its terms is found to be void or unenforceable by law in a particular jurisdiction, such portion or terms shall be interpreted and enforced to the maximum extent allowed in such jurisdiction, and the remaining provisions or any part thereof will remain in full force and effect.
This Agreement constitutes the entire agreement between Belkin and you with respect to the Software and your use thereof and supersedes any conflicting or additional terms contained in any purchase order or elsewhere. No provision of this Agreement may be waived, modified or superseded except by a written instrument accepted by Belkin and you.
However, the Belkin Privacy Policy referenced herein is subject to change in the manner described in that document. Belkin may provide translations of this Agreement as a convenience to users. However, in the event of a conflict or inconsistency between the English and any non-English versions, the English version of this Agreement shall govern, to the extent not prohibited by local law in your jurisdiction.
Any suppliers of Belkin shall be direct and intended third-party beneficiaries of this Agreement, including without limitation with respect to the disclaimers of warranties and limitations on liability set forth herein.
Other than as set forth in the preceding sentence, a person or entity who is not a party to this Agreement shall not have any right to enforce any term of this Agreement.
No failure or delay in exercising any right or remedy shall operate as a waiver of any such or any other right or remedy. The language of this Agreement shall not be construed strictly for or against either party, regardless of who drafted such language or was principally responsible for drafting it. The rights and obligations under this Agreement are not assignable by you, and any attempted assignment shall be void and without effect. This Agreement shall bind and inure to the benefit of the parties and their successors and permitted assigns.
If you are located outside of the United States, or if Section 17 does not apply to you or is otherwise unenforceable as adjudicated by a court of competent jurisdiction, then Section 18 applies to you:.
Any action arising out of or relating to this Agreement may be brought exclusively in the appropriate state or federal court in Los Angeles, California, and Belkin and you irrevocably consent to the jurisdiction of such courts and venue in Los Angeles, California. However, if you are a consumer and you live in a country where Belkin markets or distributes the Software, local law may require that certain consumer protection laws of your country of residence apply to some sections of this Agreement.
In addition, Belkin may seek injunctive relief in any court having jurisdiction to protect its intellectual property rights. Third-party trademarks mentioned are the property of their respective owners. See more languages. Support Manually setting up the Belkin router. Manually setting up the Belkin router. Share the Article:. Belkin routers can still be installed even without the use of the Setup CD.
You can set it up manually through the web-based setup page of the router. Perform the steps below to learn how: Power cycling the modem and router Manually setting up your router NOTE: Details on the steps and images may vary depending on your router model number. Power cycling the modem and router. Step 1: Unplug the modem and router from the power source.
Step 3: Power ON your modem first , then your router by plugging them back to the power source. Manually setting up your router The steps shown below may not apply to some Belkin router models. To learn how to set up a Belkin router using the Dashboard, click here. Step 1: Connect the computer to one 1 of the Ethernet ports of the router. If you are experiencing difficulties in accessing the default IP Address, click here for more troubleshooting information.
Step 3: Click Login. Step 4: Leave the Password field blank and click Submit. Step 6: Select your Connection Type and click Next. Step 7: Enter the details provided by your ISP and click the button. You should now be able to connect to the Internet. To verify, the Internet Status at the upper right corner should read Connected. You can also launch a web browser and go to your favorite website, or try visiting the Belkin Site for more information and support on your devices.
Once you have set up the Internet connection on your Belkin router, you can now proceed with configuring specific settings in your router. Check the links below:. You will not be able to reach your router if these routers are not properly installed. Also without using the setup CD, Belkin routers can still be mounted. This gives you the details for the Belkin Router installation. The following are the steps for manually configuring the Belkin Router.
Most Belkin routers have the default admin username, default password, and default These Belkin credentials are used to adjust the settings when connecting to the web interface of the Belkin router. Since certain designers are not complying with the norms, you can see the following in the table.
If none of the above sets of credentials work for you, check the backside of your router, where the password and username along with the IP address must have been written. Most users have no IP address for their router. Very often this IP is on your router device at the bottom or back. You can need to update the Wi-Fi password if you have a Belkin router. Adding a protection level to your network by changing your Wi-Fi password. The more you update it, the better—particularly when the new passwords are complicated enough.
Once accepted, this Agreement remains in effect until terminated. The limited license in this Agreement will be automatically terminated if you fail to comply with any of the terms and conditions in this Agreement. You agree that upon such termination, you will immediately destroy all programs and documentation that relate to the Software, including all copies made or obtained by you, and otherwise cease use of the Software.
If the Software has been installed on a personal computer or mobile device, you must uninstall the Software immediately. If the Software is software or firmware embedded on a Product, you must stop using the Product.
All provisions of this Agreement except for Section 1 and the limited warranty in Section 12 the first paragraph will survive termination. In addition to these remedies a "consumer" within the meaning of the CGA may claim for any reasonably foreseeable loss other than loss or damage through reduction of value of the goods that results from the initial problem. To make a claim under this Limited Warranty, return the defective media along with the sales receipt directly to Belkin at the following address: Belkin International, Inc.
This Limited Warranty is void if failure of the media has resulted from accident, abuse, or misapplication. Any replacement media will be warranted for the remainder of the original Warranty Period or thirty 30 days, whichever is longer. In relation to consumers who are entitled to the benefit of the CGA, the media on which Software is provided comes with guarantees that cannot be excluded under New Zealand law, and this Limited Warranty is in addition to any statutory rights such consumers may have under New Zealand law.
This Limited Warranty does not apply in Australia. Consumers in Australia have statutory rights in relation to the Software and media on which the Software is provided under the Australian Consumer Law. To the extent warranties cannot be disclaimed or excluded, they are limited to the duration of the relevant Warranty Period.
It is your responsibility to back up your system, including without limitation, any material, information or data that you may use or possess in connection with the Product or Software, and Belkin shall have no liability for your failure to back up your system or any material, information or data.
Some Belkin Products and Software may monitor energy consumption in the home. Belkin does not guarantee or promise any specific level of energy savings or other monetary benefit from the use of the Products or Software or any other feature. From time to time, Belkin may use the Software to provide you with information that is unique to you and your energy usage and suggests an opportunity to save money on energy bills if you adopt suggestions or features of the Product or Software.
You acknowledge that this information is not a guarantee of actual savings, and you agree not to seek monetary or other remedies from Belkin if your savings differs. We cannot guarantee that it is correct or up to date. In cases where it is critical, accessing information through the Software is not a substitute for direct access of the information in the home.
The warranties and remedies set out in this Agreement are exclusive, and, to the extent permitted by law, in lieu of all others oral or written, express or implied. You agree to strictly comply with all export control laws and regulations and agree not to export, re-export, divert, transfer or disclose any portion of the Software or any related technical information or materials, directly or indirectly, in violation of any applicable export law or regulation.
All U. Government users acquire the Software and user documentation with only those rights herein that apply to non-governmental customers. Use of either the Software or user documentation or both constitutes agreement by the U. If any portion of this Agreement or any of its terms is found to be void or unenforceable by law in a particular jurisdiction, such portion or terms shall be interpreted and enforced to the maximum extent allowed in such jurisdiction, and the remaining provisions or any part thereof will remain in full force and effect.
This Agreement constitutes the entire agreement between Belkin and you with respect to the Software and your use thereof and supersedes any conflicting or additional terms contained in any purchase order or elsewhere. No provision of this Agreement may be waived, modified or superseded except by a written instrument accepted by Belkin and you.
However, the Belkin Privacy Policy referenced herein is subject to change in the manner described in that document. Belkin may provide translations of this Agreement as a convenience to users. However, in the event of a conflict or inconsistency between the English and any non-English versions, the English version of this Agreement shall govern, to the extent not prohibited by local law in your jurisdiction.
Any suppliers of Belkin shall be direct and intended third-party beneficiaries of this Agreement, including without limitation with respect to the disclaimers of warranties and limitations on liability set forth herein. Other than as set forth in the preceding sentence, a person or entity who is not a party to this Agreement shall not have any right to enforce any term of this Agreement.
No failure or delay in exercising any right or remedy shall operate as a waiver of any such or any other right or remedy. The language of this Agreement shall not be construed strictly for or against either party, regardless of who drafted such language or was principally responsible for drafting it.
The rights and obligations under this Agreement are not assignable by you, and any attempted assignment shall be void and without effect.
0コメント